Fractionator: Difference between revisions

**<code>Belt Speed * 0,01 * Saturation Percentage * Stack Size = Deuterium Production Speed</code>

|}

 

* It is useful to build Fractionators in a conveyor loop, with one entry point for Hydrogen. This allows cycling of Hydrogen already on the belt for further conversion to Deuterium, requiring only the replacement of Hydrogen that was converted. However, limiting the loop size or replenishing hydrogen in between is crucial since every converted hydrogen will lower the efficiency of each following Fractionator in line.  

 

* The total expected output of such a Fractionator setup can be calculated using the following amended equation: <code>[Belt Speed] * [Stack Size] * ([Initial Saturation Percentage] - (0.99 ^ [Number of Fractionators])) = [Total Deuterium Production Speed]</code>

 

* This equation gives the expected total production of a 100 Fractionator setup on a Stack-1 Conveyor Belt Mk.III loop, starting at 100% saturation as <code>30 * 1 * (100% - (0.99 ^ 100) = 19.019 Deuterium/second</code>, or a system conversion rate of 63.4%. In comparison, a loop of 6 Fractionators will operate at 94,14% conversion efficiency.

 

* As a result, having multiple entry points in the conveyor loop for Hydrogen to replenish saturation, or multiple conveyor loops is recommended. With the introduction of Piler Sorters 100% efficiency can be ensured by re-stacking the Hydrogen loop in between each Fractionator, rendering the traditional single-loop setups obsolete. Thus, Piler Sorters also remove the need for limited loop size.

 

* In order to prevent clogging of the loop setup (circulation ceases) the inflowing Hydrogen conveyor must be joined to the conveyor loop in either T-shape or via [[Splitter]] with the returning Hydrogen input set as prioritized. Alternatively, the Hydrogen can be injected via sorters.  

 

* Proliferating Hydrogen increases the Fractionator's conversion rate by the Proliferator's {{glow|Production Speedup}} bonus, also applying the Energy Consumption penalty. Passing through the Fractionator does '''not''' remove the Proliferator marks from the Hydrogen unless it gets converted.

 

* The energy consumption of a Fractionator depends on the Deuterium output (or equivalently the Hydrogen Input) for Deuterium output rates below or equal to 18/m (full Mk. III Belt with Stack Size 1) the base energy consumption of 720 kW is independent of the output rate as long as it is non-zero. For Deuterium output rates above 18/min the energy consumption is given by 0.06*([Deuterium/m]-6) MW. For example a Fractionator running on a fully stacked Mk. III Belt with 72 Deuterium/m consumes 3.96 MW. When using Proliferators for  {{glow|Production Speedup}} bonus the energy consumption rate is increased as usual (20%, 70% and 150% increase when using Mk. I, II., or III. Proliferator respectively). Thus the maximal energy consumption of a single Fractionator is 9.9 MW while producing 144 Deuterium/m on a fully stacked Mk. III belt of Mk. III proliferated Hydrogen.

 

* Max throughput for a line of N fractionators processing 7200 stacked, proliferated hydrogen/minute is 7200 * (1 - 0.98 ^ N). 14 fractionators in a line will yield an average 1773 deuterium / minute, not quite saturating an output belt. Alternately 2 lines of 6 fractionators on either side of a single output belt will yield 1643/m.